Hi all,
We use both cricket and nmis as tools to monitor our network with snmp.
Both tools also read our 12008's CPU utilization.
But only the CPU utilization of the GRP's
And not the individial slots.
Can anyone give pointers how I can let our tools monitor/graph the CPU utilization of each individual processor?
I think I have to load a/certain MIB(S).
But I cant find which one I should use.
TIA,
Bastiaan
ps
IOS 12.0.26S
cisco 12008/GRP (R5000) processor (revision 0x05) with 262144K bytes of memory.
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
Last reset from power-on
1 Route Processor Card
2 Clock Scheduler Cards
3 Switch Fabric Cards
6 Single Port Gigabit Ethernet/IEEE 802.3z controllers (6 GigabitEthernet).
1 eight-port FastEthernet/IEEE 802.3u controller (8 FastEthernet).
1 Ethernet/IEEE 802.3 interface(s)
8 FastEthernet/IEEE 802.3 interface(s)
6 GigabitEthernet/IEEE 802.3 interface(s)
507K bytes of non-volatile configuration memory.
