04-09-2004 07:01 AM - edited 03-02-2019 02:54 PM
*Mar 6 21:17:57.120: %CONTROLLER-2-FIRMWARE: Controller T1 0/0, firmware is not
running
This is the error i get
I have 3 VWIC-2MFT-T1 cards in them the card in slot has no lights on it i have tried other cards with the same result. I have upgraded SW as well. Same thing.
Any ideas? Is this thing junk?
Thx
04-09-2004 08:56 AM
Can you paste a show version output.
04-09-2004 02:08 PM
Sure, Here you go
UNI-3725#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3700 Software (C3725-I-M), Version 12.3(6), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 15:42 by kellythw
Image text-base: 0x60008AF4, data-base: 0x60D94000
ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)
UNI-3725 uptime is 6 days, 4 hours, 25 minutes
System returned to ROM by power-on
System image file is "flash:c3725-i-mz.123-6.bin"
cisco 3725 (R7000) processor (revision 0.1) with 120832K/10240K bytes of memory.
Processor board ID JHY0807K02A
R7000 CPU at 240MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
3 Serial network interface(s)
4 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
55K bytes of non-volatile configuration memory.
31744K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
04-09-2004 03:25 PM
Weird that you have 3 VWCI-2MFT-T1s and it shows up only 4 T1 PRI controllers. What slots have you inserted these VWICs ? Are these on NM-HDVs or have you inserted in the Base I/O controller module of the 3725 ?
04-10-2004 06:49 AM
Actually What i did was took one of them out and put in a regular WIC-1DSU-T1 and they are on the base controller I also have a NM-2W in there but its not being used
04-10-2004 07:28 PM
Try using a T train IOS.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide