Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
338
Views
0
Helpful
2
Replies

Token Ring and cabling

igorbelskiy
Level 1
Level 1

‎09-03-2003 08:38 AM - edited ‎03-02-2019 10:04 AM

On C7206 I have ToR port adapter. This adapter may work in concentrator mode or port mode. I want to connect 2 hosts to that ToR PA. What type cables can I use to make the connections? Is it possible to use stright-through CAT5 patch cords?

Labels:
0 Helpful
2 Replies 2

robhorniachek
Level 1
Level 1

‎09-03-2003 11:22 AM

You will need a true straight-through cable - TR uses pins 3,4,5, and 6, while ethernet uses 1,2,3 and 6. Make sure pin 3 goes straight through to pin 3, and you should be OK.

BTW - IBM designed TR over UTP/STP to use the inside pins on the connectors to 'protect' the connection - if the connector is damaged, it's usually the outside pins that are affected - using the inside pins was supposed to make sure the connector could still be used...

0 Helpful

igorbelskiy
Level 1
Level 1
In response to robhorniachek

‎09-03-2003 11:35 AM

Thanks for the answer.

0 Helpful
Customers Also Viewed These Support Documents