02-20-2004 12:32 AM - edited 03-02-2019 01:44 PM
I have a unique problem. I have recently installed a cable router uBR 905 at a customer location. It has IOS 12.2(4)T release fc1. I configured dynamic NAT for a Class C local IP pool onto a global pool with 2 IP addresses from a subnet of 8 IP's. It is observed that the router NAT process stops every morning though the router is online. 'sh ip nat translation' command does not show any active translations. The router though is accessible from the network side and has to be rebooted for the NAT to work. It then works fine for the day but again the next morning the same problem arises. The CPU Utilisation is also not very high...of the order of 5%. The electrical voltages when checked are also according to specifications.
I have installed 2 other routers with the same hardware and IOS versions but they have never given such a problem. Could anybody give me a clue as to why this could happen?? What could be the probable reasons??
02-26-2004 08:04 AM
hope using route-maps with NAT may solve your problem.
ip nat inside source route-map test pool global overload
ip nat pool global 10.1.1.1 10.1.1.1 netmask 255.255.255.240
route-map test permit 10
match ip adress 100
access-list 100 permit ip 10.2.2.0 0.0.0.255 any
access-list 100 permit ip 192.168.2.0 0.0.0.255 any
And also you can try to upgrade your IOS and test it.
02-26-2004 08:36 PM
Dear Friend,
Thanx for your help! But I dont think route maps could help out, as I do have matches on the access-list when I execute the 'sh ip access-lists' command. Only the NATing does not happen.
Although changing the IOS could be tried out. I shall definitely check that option and let you know.
Thanx for your help anyways!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide