cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
321
Views
0
Helpful
1
Replies

VIP4-50 INSTALLATION PROBLEM

Hi

I need to install a new VIP4-50 on my Router 7500. This is the show version output

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(7)T, RELEASE SOFTWARE (fc2)

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 06-Dec-99 19:40 by phanguye

Image text-base: 0x60010908, data-base: 0x61356000

ROM: System Bootstrap, Version 11.1(2) [nitin 2], RELEASE SOFTWARE (fc1)

BOOTFLASH: GS Software (RSP-BOOT-M), Version 11.1(8)CA1, EARLY DEPLOYMENT RELEAS

E SOFTWARE (fc1)

er-prueba01 uptime is 17 minutes

System returned to ROM by reload at 17:05:21 GMT-4 Tue Aug 10 2004

System restarted at 10:43:23 GMT-4 Wed Aug 11 2004

System image file is "slot0:rsp-jsv-mz.120-7.T.bin"

cisco RSP2 (R4700) processor with 32768K/2072K bytes of memory.

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Last reset from power-on

G.703/E1 software, Version 1.0.

G.703/JT2 software, Version 1.0.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

Bridging software

TN3270 Emulation software.

Chassis Interface.

1 EIP controller (6 Ethernet).

6 Ethernet/IEEE 802.3 interface(s)

123K bytes of non-volatile configuration memory.

16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).

8192K bytes of Flash internal SIMM (Sector size 256K).

No slave installed in slot 6.

Configuration register is 0x102

Do I have upgrade the IOS?

What should I consider beside the IOS upgrade to do a succesfully installation?

Thanks

Regards

Leo

1 Reply 1

deilert
Level 6
Level 6

see this field notice

http://www.cisco.com/en/US/products/hw/routers/ps359/products_field_notice09186a0080094300.shtml

I would get off 12.0(7)T as soon as possible this was not very stabre code

Review Cisco Networking for a $25 gift card