03-10-2005 04:45 PM - edited 03-02-2019 10:06 PM
I am adding a VPN circuit to a branch location that has a frame relay link. I would like to send specified traffic over the links (i.e. exchange traffic over VPN, SAP over Frame Relay). What is the best way to accomplished this setup?
p.s. Both circuits originate in a 2821 router.
03-11-2005 06:26 AM
To make different routing decisions based on the type of traffic you will need to implement Policy Based Routing.
The essential concept of Policy Based Routing is that PBR will over-ride the normal routing decision based on a route map.
The general approach that you would take would be to establish your normal routing. I would suggest that it might be easier to set up routing so that normal traffic would take the Frame Relay path. Then you configure an extended access list which permits the traffic which you want to send over the VPN (Exchange or whatever). Then configure a route map which uses the access list to identify the traffic and set the next hop so that it will go over the VPN.
HTH
Rick
03-11-2005 07:09 AM
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide