I plan to use this configuration:
CISCO2611XM Dual 10/100 Ethernet Router w/ Cisco IOS IP
S26CP-12208T= Cisco 2600 Series IOS IP PLUS
NM-2V= Two-Slot Voice/fax Network Module-Spare
VIC-4FXS/DID= 4 port FXS or DID VIC
WIC-1T= 1-Port Serial WAN Interface Card
CAB-V35MT= V.35 Cable, DTE, Male, 10 Feet
But in configurator tool it only permits to use the vic-4fxs/did with NM-HDV2, but in other info it say that vic-4fxs/did module is used only with 1700 series.
Please confir what I need in order to be able to use vic-4fxs/did with Cisco 2611XM
Thanks