I am having issues accessing the landing page of my Cisco 2504 wireless controller appliance to manage my APs. Currently my APs are unable to see the wireless controller since the IP address of the appliance is not in the UP state. What I have done is the following commands through CLI:
(WLC) >config network webmode enable
(WLC) >config network secureweb enable
You must reboot for the change to take effect.
If you are still having the issue then try these 2 commands and check it.
config network mgmt-via-wireless enable
config network mgmt-via-dynamic-interface enable
After this I have saved the running configuration and reboot the appliance the GUI still does not display.
