Port erroring - disabled state

[magruff]

I'm using a Catalyst 3560x to run a Digital Audio network. It looks like every once in a while one/some of the networked devices will send erroneous data (link flap) that leads to the switch shutting the port down:

4-ERR_DISABLE: link-flap error detected on Gi0/18, putting Gi0/18 in err-disable state

I'm working on a fix for the bad data being passed to the switch but in the meantime I'd like to know if there is a way to resume service on the port without power cycling the entire switch. Any help would be greatly appreciated. 

[luis_cordova]

Hi @magruff ,

Check this disscusion:

https://community.cisco.com/t5/routing/pm-4-err-disable/td-p/516539

And this link:

https://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/69980-errdisable-recovery.html

Regards

[magruff]

Thank you very much for the response, exactly what I was looking for.

[luis_cordova]

Hi @magruff ,

I'm glad to help you.

Remember to mark the correct answers as solved, since it helps other users with similar doubts.

Regards