11-28-2004 10:36 AM - edited 03-02-2019 08:14 PM
When configuring an ATM switch, I noticed that when a PVC is configured under an interface it might not necessarily appear under that specific interface but instead under the remote interface on wich the PVC is switched
So, if I configure
int atm0/0
PVC 100 100 interface ATM 1/1 200 200
when I do show run, this config appears under ATM1/1 as
PVC 200 200 interface ATM 0/0 100 100
Is there a rule that controls this behaviour, I suspect it is soemthing to do with VPI values ??
Any comments or links appreciated.
12-03-2004 07:24 AM
check the below config for a sample config
http://www.cisco.com/univercd/cc/td/doc/product/atm/c8540/q_config/svc.htm#xtocid38595
12-05-2004 05:30 AM
Thanks for th elink, but I think u miss understood my question.
I know how to configure PVC on a switch, my problem is why doesn't the config always show under the interface it is configured under.
U think the rule is that the config line wil always show under the highest interface.
So If u configure a X-connection between ATM0/0/0 and ATM0/0/1, and u do this under ATM0/0/0...ut will show under ATM0/0/1 and not ATM0/0/0.
Sam
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide