03-20-2003 12:43 AM - edited 03-02-2019 06:00 AM
We are connected with fiber optic on STM1 (0c3) system directly with telco, We have a total of 3 cisco routers, one "7206VXR" (Gateway Router),and two "7206" which are configured to load balance the l2tp traffic thru Policy Based Routing.
We configured our ADSL on gateway router and currently imlplementing bandwidth control on per ATM sub interfaces, We managed to control on point to point sub interface, that is e.g. "interface ATM6/0.274 point-to-point, while it does not seem to work in multipoint sub interface, that is e.g. "interface
ATM6/0.150 multipoint"
Below is an example of each one
interface ATM6/0.150 multipoint
description ADSL Multipoint for Personal Customers
rate-limit input 2000000 128000 128000 conform-action transmit exceed-action drop
rate-limit output 2000000 128000 128000 conform-action transmit exceed-action drop
(Above does not work)
interface ATM6/0.274 point to point
description ADSL Multipoint for Personal Customers
rate-limit input 64000 32000 32000 conform-action transmit exceed-action drop
rate-limit output 64000 32000 32000 conform-action transmit exceed-action drop
(this one works fine)
PLs! Help!
03-26-2003 07:50 AM
Rate limiting on the ATM multipoint subinterface requires CEF switching to be enabled... confirm that this is enabled on the interface or globally.
03-27-2003 12:20 AM
Dear,
It is enable globally, I am just wondering why it does not work in multipoint, while point to point works fine
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide