Hi,
i have two routers R1 and R2 connected by EBGP.
The configurations in R1 is
R1#sh run
Building configuration...
Current configuration : 589 bytes
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname R1
!
!
ip subnet-zero
!
!
!
!
interface Ethernet0/0
no ip address
shutdown
!
interface Ethernet1/0
no ip address
shutdown
!
interface Serial2/0
ip address 10.1.1.1 255.255.255.0
!
interface Serial3/0
no ip address
shutdown
!
router bgp 100
no synchronization
bgp log-neighbor-changes
neighbor 10.1.1.2 remote-as 200
!
ip classless
no ip http server
ip pim bidir-enable
!
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
login
!
end
R1#
The configuration in R2 is
R2#sh ip bgp
R2#sh run
Building configuration...
Current configuration : 607 bytes
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname R2
!
!
ip subnet-zero
!
!
!
!
interface Ethernet0/0
no ip address
shutdown
!
interface Ethernet1/0
no ip address
shutdown
!
interface Serial2/0
ip address 10.1.1.2 255.255.255.0
!
interface Serial3/0
ip address 20.1.1.1 255.255.255.0
!
router bgp 200
no synchronization
bgp log-neighbor-changes
neighbor 10.1.1.1 remote-as 100
!
ip classless
no ip http server
ip pim bidir-enable
!
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
!
end
R2#
The routers are in established state and show ip bgp summary is as given below
R1#sh ip bgp su
BGP router identifier 10.1.1.1, local AS number 100
BGP table version is 11, main routing table version 11
1 network entries and 0 paths using 97 bytes of memory
0 BGP path attribute entries using 0 bytes of memory
0 BGP route-map cache entries using 0 bytes of memory
0 BGP filter-list cache entries using 0 bytes of memory
BGP activity 1/2 prefixes, 5/5 paths, scan interval 15 secs
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
10.1.1.2 4 200 8 8 11 0 0 00:04:46 0
R1#
R2#sh ip bgp su
BGP router identifier 20.1.1.1, local AS number 200
BGP table version is 1, main routing table version 1
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
10.1.1.1 4 100 4 4 1 0 0 00:00:13 0
20.1.1.2 4 200 4 4 1 0 0 00:00:25 0
R2#
Problem is if we see show ip bgp no output will be generared.
R1#sh ip bgp
R1#
R2#sh ip bgp
R2#
Anybody know this so?
