30 channels of 64 K to give 2 MB channelised interface.

[mecnet]

WE have got a central location with a 3640 router.

We are getting 30 64 K lines coming in from 30 locations.

Can we aggregate these 30 nos 64 K lines at the leased line service provider and get it to our premises over a 2 MB link and place it into the

1 port channelised E1 ISDN PRI card.

We should be able to assign saperate IP address to each of the channel of this channelised 2 MB.

THus we wish to create a WAN with 30 different location from the central office but use only 1 no. of 2 MB modem at teh central location, instead of 30 nos of 64 K modems.

MAngesh

[ciscomoderator]

The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

[faheyd]

http://www.cisco.com/warp/public/cc/pd/rt/3600/prodlit/isdnp_ds.htm