08-25-2008 09:18 AM - edited 03-09-2019 09:20 PM
Hi,
I have a a setup with one CAM, one CAS and a firewall between them. There is also NAT in place.
I changed the requiered things like in the configuration guide.
After the changes, I'm able to connect the CAM with the CAS. But after the a reboot of the CAS the connection is broken and cannot be "repaired" because the CAM tries to connect to the original IP and not to the NAT IP which it was connected to earlier. I can only "repair" the connection when I delete the CAS on the CAM an reinitiate the connection.
Any ideas?
regards Dirk
08-29-2008 08:30 AM
When using NAT on the trusted (eth0) side of the CAS, the CAS remains manageable by the CAM by passing the NATed service IP address to the CAM using the "autoconnect" feature.
12-11-2008 04:16 AM
hi
"When using NAT on the trusted (eth0) side of the CAS, the CAS remains manageable by the CAM by passing the NATed service IP address to the CAM using the "autoconnect" feature."
how to activate "autoconnect" feature
best regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide