Hi, I have a doubt with rules in CSA, Right now I can do policy, and rule module, and group, but I cann't generate rules?I need anyclue for this troubleThanks
1x Catalyst 3560.GUEST VLANSTAFF VLANI have 2 separate VLANS.Requirement: Guest Vlan deny access to Staff Vlan. Staff Vlan permit access to Guest Vlan.Is this setup possible? Apparently im able to deny access from guest->staff, but not vice versa.GUE...
How can I authenticate the MARS when it sends an email to an account on different domain.Our mail server requires authentication to send mail.Thanks.Andrea.
Hi. Our Cisco 877 router was rebooted recently. Initially, after the reboot client had no internet access at all (I didnt do the initial config and I suspect whoever did didn't save it to startup). I added the http inspect command and internet access...
HiMy CS-Mars 110 had crashed for some unknown reason. After reload the device works fine but there is an error with the raid-10 which shows a status of "Degraded", please see attached file.Is there a way to solve this problem?Thanks
Hi All !I have set up an ASA5510 to access internet using a DSL line via PPPoE.The PPPoE client connects, authenticates and almost everything is fine, except the DNS server. Normally, the ISP provides the DNS server for the PPPoE client to use, anthi...
I have been getting some errors with my MARS box over the last couple days when adding in devices. When trying to do an SNMP discovery from the device add page, I am getting this error:There is no Error Log for this Device.I have looked through the ...
Hello,Is someone know, in MARS 5.3 , if there is a partculiar command of line, in the XML file ( for adding non standard signature) to get signature ?The sever used is APACHE one and the MARS Server didn't get even try the Get request ?
Hello,I want to configure my router to be able to access SDM from Internet. If u configure this from SDM: Configure, Additional Tasks, Router Access, Management Access. Here I can Add an access policy. I want to do this by CLI not from SDM. Especialy...
Does anybody know how to collect either the "Error Events" or the "Status Events" from 4200 series IPS devices in CS-MARS? The only events that seem to be collected by CS-MARS are the "Alert Events".
In CSA 4.0 and 4.5 it was very easy to enable Agent Service Control rule to allow only administrators the ability to stop the CSAgent service. However in CSA 5.0, that checkbox has been removed from the Agent Service Control rule screen. You can as...
We have a couple VPN routers that are failing a Qualys scan b/c of the existence of the default ISAKMP policy. "show crypto isakmp policy" shows this as the "default protection suite". I'm looking for a way to disable this policy or, better yet, remo...
