04-09-2002 06:44 AM - edited 03-08-2019 10:16 PM
Following the info found on the web on how to change the ENABLE password on my 2500 I can no longer ENABLE.
The commands I used were
ena
(old ENA pass)
configure
enable password 7 newpass
exit
Now newpass is rejected when I enable
Any ideas would be much appreciated..
Phil
IT SUpport
Zetex
04-10-2002 06:47 PM
you didnt need to type '7'
try this for your enable pass:
'7 password'
-ne1secure?
04-10-2002 08:56 PM
I don't know your case, but just to remember that you should also consider the following CISCO recommendations:
"... When setting passwords for privileged access to the firewall, use the enable secret command rather than the enable password command, which does not have as strong an encryption algorithm..."
[], Monteiro
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide