Hosts unreachable

[albertobrivio]

Dear All,

I have a PIX515E version 6.3

I have a web server on inside and other web servers over dmzs

From each of one all servers, sites are reachable, so if I am connected to inside's host I can

browse internet sites on the other servers and viceversa.

Then, I have installed a 1720 router in the inside, so I can increase number of subnet belonging

to one interface, in this case to the inside.

Each host has router as gateway and for each subnet I have to add this command in the Pix:

route inside subnet address subnet mask gateway

Every thing seems run properly, but host are no more reachable between them like I have

explained above.

Anyone of you could give me an help?

Regards

Alberto Brivio

[Fernando_Meza]

Hi ..

Because you have created new segments, the IP addresses for the inside hosts has been probably changed as well and if so you will need to make sure the PIX allows that traffic on any access-list applied to the inside interface and to the DMZ's interface. You moght have to check your NAT access as well ..

I hope it helps .. please rate it if it does !!!!