04-19-2006 06:15 AM - edited 03-09-2019 02:39 PM
Hi
I have an active/standby pair of pix 515e firewalls. How can I find out which one is the active one, and which is in standby?
Thanks for your help
Dan
Solved! Go to Solution.
04-19-2006 06:46 AM
Enter the following command:
show faiover
pix(config)# show failover
Failover On
Serial Failover Cable status: My side not connected
Reconnect timeout 0:00:00
Poll frequency 15 seconds
Last Failover at: 18:32:16 UTC Mon Apr 7 2003
This host: Primary - Active
Active time: 510 (sec)
Interface 4th (172.16.1.1): Normal
Interface intf2 (192.168.2.1): Normal
Interface outside (192.168.1.1): Normal
Interface inside (10.1.1.1): Normal
Other host: Secondary - Standby
Active time: 0 (sec)
Interface 4th (172.16.1.2): Normal
Interface intf2 (192.168.2.2): Normal
Interface outside (192.168.1.2): Normal
Interface inside (10.1.1.2): Normal
sincerely
Patrick
04-19-2006 06:46 AM
enter the command:
sh failover
to see the actual status.
04-19-2006 06:46 AM
Enter the following command:
show faiover
pix(config)# show failover
Failover On
Serial Failover Cable status: My side not connected
Reconnect timeout 0:00:00
Poll frequency 15 seconds
Last Failover at: 18:32:16 UTC Mon Apr 7 2003
This host: Primary - Active
Active time: 510 (sec)
Interface 4th (172.16.1.1): Normal
Interface intf2 (192.168.2.1): Normal
Interface outside (192.168.1.1): Normal
Interface inside (10.1.1.1): Normal
Other host: Secondary - Standby
Active time: 0 (sec)
Interface 4th (172.16.1.2): Normal
Interface intf2 (192.168.2.2): Normal
Interface outside (192.168.1.2): Normal
Interface inside (10.1.1.2): Normal
sincerely
Patrick
04-19-2006 07:06 AM
Hi
Thanks for the replies. It makes things a lot clearer now.
Thanks
Dan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide