Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have some questions regading portchannels. (Ether channels)Is it possible to connected a L3 portchannel and a L2 portchannel. Where on the L3 switch the portchannel is a L3 port-channel and on the L2 switch a L2 port-channel.L3 switch, for examp...
I am having a problem connecting a c2950 through a single vlan port to another c2950 port in native vlan (1).I have one c2950 in which i changed the managment vlan to 10. I changed one port on that switch to vlan 10 (non trunk) and connected it to...
This is normal behavior on an L3 switch, since the processesing of the ip packets is done in hardware.U won't see any matches on ACL except for packets that are proccesed by the CPU. That also explain why u do get hits on the 2nd rule. The "log" keyw...
As Christos already the error message indicated TCAM table doesn't have enough room te store all the routes in your routing table.If the routes are not able to store in the TCAM that means the traffic to that destination isn't switched in hardware a...
U can't use your outside ip address configured on the interface for static translation. That setup is not possible, that the reason ur internet failed when u put on the static.====Now this is not working with PIX. When the users change to 10.1.1.10 o...
so mail.testclient.com is pointing to 11.12.13.14 which is the external (nat) adres on the Pix firewall. Assume when u say internal u mean behind the inside of the pix firewall the problem is inside users can't connect to the 11.12.13.14. thats the ...
