LOST PDM ?

[dopenfield]

I seem to have lost the ability to attach to a Pix 525 running 6.2 using the PDM interface. Reloading the PIX hasn't helped.

No error message in the log. Browser just says can't find server. I was in this PIX using PDM just two days ago and nothing has been changed since then.

I can still get in using Telnet and I am still able to go through the Pix to the Internet.

Any ideas what to check?

[jmia]

Hello Doug -

Have you got 'http server enabled' on you PIX config ? and http 255.255.255.255 inside cmd ?

Were, inside IP addrs is the client that is using the PDM, also make sure to use 'static IP addrs' for the inside IP addrs.

Hope this helps --

[dopenfield]

I do have http server enabled and pdm location configured with the correct IP address ranges.

Still no response when trying to connect from a browser. Nothing had been changed on this PIX between the last successful connection to PDM and when the failure was noted.

Anyone have any other thoughts.

[tvanginneken]

Hi,

try clearing the offline content of your browser (CTRL-F5 on Windows).

ps make sure you are using https (and not http).

Kind Regards,

Tom

[grw]

Upgrading the PDM software fixes this issue, however if you and delete your offline files in your browser you will be able to get back into the PDM. Good Luck.

[l.mourits]

take a look at this thread, and see if this works for you too :

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.ee9bb50

Kind Regards,

Leo