Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am setting up SSL vpn on an ASA v7.2. I am using the Cisco SSL VPN client. The client receives an IP address from a ip pool that I assigned to the ssl vpn clients. I am able to setup the ssl tunnel and I receive an IP address from the pool. Ever...
Hi,I am setting up SSL vpn on an ASA v7.2. I am using the Cisco SSL VPN client. The client receives an IP address from a ip pool that I assigned to the ssl vpn clients. I am able to setup the ssl tunnel and I receive an IP address from the pool. Ever...
Hi,we are trying to make a inventory of a remote site and we want to know if there is a way to find out if a router is a 2620 or a 2620XM? We also need to know the serial number of the router.We tried a "show version" but this doesn't give me the nec...
Hi,a customer of us can not setup a PPTP connection from a wireless client to a wired PPTP server on the network through a Cisco Aironet 1100. Are there some known issues regarding this topic? Are there some incompatibilities between the Aironet and ...
My client-pc is connected to a C2950 switch that is configured for 802.1X port authentication. The C2950 switch forwards the pc authetication request to a Cisco ACS Radius server version 3.2.Which RADIUS attributes need to be set on ACS Radius server...
Hi Chris,could you have a look in the config and see if the is already a "boot system" command present? Remove it (if it's there) and replace it with the right one.Regards,Tom
Hi,you can use a single static statement to 'static nat' an entire network (or subnet). It is the same static command that you use for one host, but instead of specifying a 'host' ip address, you specify the 'network' ip address. Like this:static (in...
