NAT problem

[e.frias]

Hi

I need to know if there is any way to do a translation based on a condition. For example, if the destination is a specific network then the translated address should be a specific address, but if the destination is a different network then the translated address is a different address.

I hope somebody can help me with this, because i need to implement it for a VPN.

Regards!

EF

[mostiguy]

what device are you using?

[e.frias]

I´m using a 1700 router.

[federico_caminos]

Hi EF

I think this document will help you , you can find a very detailed example using ACLs or Route Maps.

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080093fca.shtml

FEC