Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two nexus 5596UP switches operating in VPC mode working well.I have a doubt about connecting a server to both 5596 in Active / Passive nic teaming mode, ther is no LACP support on the server side.One interface of the server will be Activ...
Hello, I just need to start building the configuration of an ASR 1001 but I do not know how gigabitethernet interfaces are named on these routers?Are Gi0/0/X or Gi0/X ??Can someone upload a sample config?Thank you.
Hello !Please someone explain me why this command will show mac addresses for the standby supervisor, and how can I enable/disable this feature.Version is sup-bootdisk:s72033-advipservicesk9_wan-mz.122-33.SXI1.bin6509-1#show mac-address-table dynamic...
We have a QinQ tunnel configured between two 7609.The tunnel is used to connect two L2 switches (one 6509 and a 3750). The problem that we have is with different inner vlans (vlan 501 and vlan 621) with same mac-addresses.The moment we enable both vl...
Hello:Can a CSS load balance in cascade?Can CSS 11503 load balance multiple server farms (web farm, Database Farm, Storage farm) using different vlan subnets for each server farm, if I am right, this is called CSS router mode.Every server farm will h...
HiThe thing is I have a second switch , same hardware configuration and IOS version , but this second switch will not display the same command with mac address from StandBy supervisor6509-2#sh mac-address-table dynamic vlan 14Legend: * - primary entr...
Hi,Yes it should, provided that it is enabled first.You can enable proxyarp on an interface by configuring the noproxyarp commandno sysopt noproxyarp outsideHope this helps.
