HI Raj,
According to the way you have deployed your NAC Appliance,
I can't figure out whether you have VLAN Problem on the Interface Connected to the Other Switch or the Interface Connected to the CAS.
If the Problem is on the Switching side then there is problem in the Trunk between the Switched.
Do not use Access Links in VG mode, Use Trunk And Allow VLANS ok
If the Problem is on the CAS Side, Again Configure Trunks properly and Set Native Vlan As A Dummy VLAN,SAy 999.
IF this Help Was Enough, PLease Rate or Mark as Answered so that it may be helpful for others.
Regards
Edward
In case of any Further Help, Post a Reply.
**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**
Please Rate if helpful.
Regards
Ed