12-21-2004 08:40 PM - edited 03-09-2019 09:49 AM
Hi,
I have PIX515 with 5.3. Currently I cannot get into the PDM because I forget the password.
Could anyone tell me, how to add a name with password in CLI so I can use it for PDM?
Thank you
Hendarto
12-21-2004 09:36 PM
Connect to the CLI:
enable
conf t
username YOURUSER password YOURPASSWORD privilege 15
you can remove account with:
no username YOURUSER
Add it again, this is like a password recovery:
username YOURUSER password YOURPASSWORD privilege 15
sincerely
Patrick
12-22-2004 10:14 AM
Try leaving the username field blank and entering the enable password in the password field.
Perhaps you're using AAA authentication in which case my suggestion won't help. Patrick's suggestion above will handle the situation nicely.
Regards,
Craig
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide