05-30-2004 02:43 AM - edited 03-09-2019 07:33 AM
Greeting every one
I have installed the PIX-4FE-66 card in the first slot of PIX-525 but its is not working, whenever I put the command nameif ethernet4 perimeter1 sec50 the pix start saying unrecognized hardware.
Any comment please.
Here is a partial output of show tech-support command :
Cisco Secure PIX Firewall Version 5.3(1)
Compiled on Tue 05-Dec-00 17:51 by morlee
pixfirewall up 15 hours 43 mins
Hardware: PIX-525, 128 MB RAM, CPU Pentium III 600 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
0: ethernet0: address is 0006.5336.83d7, irq 10
1: ethernet1: address is 0006.5336.83d8, irq 11
Licensed Features:
Failover: Disabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 6
Cut-through Proxy: Enabled
Guards: Enabled
Websense: Enabled
Throughput: Unlimited
ISAKMP peers: Unlimited
Serial Number: 405290368 (0x18283d80)
Activation Key: 0x0a7cbda3 0xfe0776b7 0xd28a8261 0xa48afd71
05-30-2004 06:09 AM
I think that you have upgrade your software version.
The product licterature explane the system requeriments:
>>> Operating system Cisco PIX Security Appliance Software versions 5.2(9), 6.0(4), 6.1(4), 6.2(2), and 6.3(1) or later
>>> Platforms Cisco PIX 515/515E, 520, 525, and 535 Security Appliance
I´m not sure, but the software 5.2(9) is earlier than
5.3(1). I try find the PIX OS Roadmap and don´t have success.
Regards,
Kratz
05-30-2004 10:22 AM
I will upgrade the OS to 6.3 tomorrow morning, let's see what's gonna happen.
thanks,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide