cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
596
Views
0
Helpful
1
Replies

PIX501 - PDM - Unsupported Command Found

andre.ortega
Enthusiast
Enthusiast

Hi,

I am using a PIX501 with PDM 3.0(4) and PIX OS 6.3(5) and I cant use PDM to make configurations.

When a try open Configuration tab in PDM a message "Unsupported Command Found"

1 Accepted Solution

Accepted Solutions

Panos Kampanakis
Cisco Employee
Cisco Employee

Do you have "nat (interface access-list" commands in the PIX?

If you do PDM will not wor with them as the error says.

Try to change the nat with acl as a nat with a subnet and then PDM is going to work.

I hope it helps.

PK

View solution in original post

1 Reply 1

Panos Kampanakis
Cisco Employee
Cisco Employee

Do you have "nat (interface access-list" commands in the PIX?

If you do PDM will not wor with them as the error says.

Try to change the nat with acl as a nat with a subnet and then PDM is going to work.

I hope it helps.

PK

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers