PIXOS 7.0

[johnleeee]

Sorry for missed out text.I had problems with my

browser.

So here is question.

--------------------------------------

I have general question about

configuration of NAT in version of PIXOS 7.0 nat-control and no nat-control.

When I configure this it will apply to

all PIX. But, its possible exclude this

for some configuration from PIX? So use

default behavior (nat-control)?

BR

jl

[jackko]

with "nat-control" disabled, you can still configure nat where required.

e.g. you can disable "nat-control", so that traffic between inside and dmz will permit without nat/pat. and at the same time, you can create pat for inside to browse the internet.

[johnleeee]

Hi jack,

thanks for reply..so as I understand when

I switch off NAT control I must not use it.

On the other hand when I want use it for specific traffic I can do this.

regards

jl

[jackko]

i suggest you to disable "nat-control", and you can configure the nat/global/static wherever is needed. it's more flexible.

according to cisco:

Why should I rate posts?

If you see a post that you think deserves recognition, please take a moment to rate it.

You'll be helping yourself and others to quickly identify useful content -- as determined by members. And you'll be ensuring that people who generously share their expertise are properly acknowledged. As posts are rated, the value of those ratings are accumulated as "points" and summarized on the Member Profile page and on each member's Preferences page.