REMOTE DESKOP GATEWAY IN DMZ

[ktzouv001]

Hello,

I am new in the community.

I have Cisco ASA 5510 and i have DMZ,INSIDE,OUTSIDE Interface.

I am sure that yu have hear lot of times tis question but before write i have try lot of things without n result.

I have an Remote Desktop Gateway in DMZ.

My problem is that when i try to connect froM Outside i see that connected but can't authenticate the user and ask all the time for password.

• I have create access rule to allow https in RDG
• i have create access rules for ports that must be opened to communicate RDG with INTERNAL NETWORK base on https://blogs.technet.microsoft.com/enterprisemobility/2009/07/31/rd-gateway-deployment-in-a-perimeter-network-firewall-rules/
• I have create the nat to allow Internet from DMZ Network
• I have create the NAT to map the inside IP of DMZ with outside IP of DMZ.

What else must configure to connect users from outside through RDG.

[Philip D'Ath]

Does the firewall say it is blocking anything?

[ktzouv001]

Hi Philip,

Finally i found that the problem is with RPC – RPC Dynamic ports. Unfortunately i must configure a specific range for the RPC – RPC Dynamic Ports.

Do you know any other solution that can use Remote Desktop Gateway in DMZ without need to do this configuration because i must change registry settings that i don't prefer.