Translate all inbound traffic to one source address?

[jason.scott]

Hi,

Is it possible to change the source address for all traffic coming from my outside interface heading for my DMZ interface to 1 static address?

I know its possible to translate individual addresses with static (outside,dmz) but not sure how to do this for all outside addresses.

[nsteup]

Yes it is. You can do NAT from outside to the inside interface IP address or a NAT Pool. Best to do this is a policy based NAT. If you define it globally, you must do a NAT excemption for all of your outbound NAT configurations in the inbound direction.

Regards,

Norbert

[jmia]

Jason,

As per Norbert's reply take look here on Policy NAT:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172786.html#wp1113601

Hope it helps,

Jay