cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
707
Views
0
Helpful
3
Replies

VLAN Configuration using a Layer 3 Services Module

vern.saunders
Level 1
Level 1

I'm trying to configure inter-VLAN routing on a Cat 4006. I have configured 2 VLANs and I have a PC in each. I can't ping across VLANs for some reason. Any suggestions?

3 Replies 3

ciscomoderator
Community Manager
Community Manager

The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

millerv
Level 1
Level 1

What does show IP route say?

d-lau
Level 1
Level 1

1st thing 1st, have you purchased the Enhanced IP License for the L3 module?