04-18-2001 09:37 AM - edited 03-08-2019 08:10 PM
I'm trying to configure inter-VLAN routing on a Cat 4006. I have configured 2 VLANs and I have a PC in each. I can't ping across VLANs for some reason. Any suggestions?
04-23-2001 10:19 AM
The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.
If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-24-2001 01:48 PM
What does show IP route say?
04-25-2001 05:44 AM
1st thing 1st, have you purchased the Enhanced IP License for the L3 module?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide