Cisco ASA question
2 Questions:
1-why cant i see interface eth1/2 and 1/3 in output?
2-Also, how to find out which ports are part of port-channel?
fw# show int ip brief
Interface IP-Address OK? Method Status Protocol
Internal-Data0/0 unassigned YES unset up up
Internal-Data0/1 unassigned YES unset up up
Internal-Data0/2 169.254.1.1 YES unset up up
Port-channel1 unassigned YES unset up up
Port-channel1.900 172.18.127.133 YES CONFIG up up
Ethernet1/1 90.216.253.11 YES CONFIG up up
Ethernet1/4 unassigned YES unset admin down down
Ethernet1/5 unassigned YES unset admin down down
Ethernet1/6 unassigned YES unset admin down down
Ethernet1/7 unassigned YES unset admin down down
Ethernet1/8 unassigned YES unset admin down down
BVI1 unassigned YES unset up up
show interface port-channel 1.900
Interface Port-channel1.900 "mylab", is up, line protocol is up
Hardware is EtherSVI, BW 20000 Mbps, DLY 10 usec
VLAN identifier 900
Description:
MAC address 9077.ee57.769a, MTU 1500
IP address 172.18.127.133, subnet mask 255.255.255.248
Traffic Statistics for "myab":
17920 packets input, 845126 bytes
17651 packets output, 497732 bytes
54 packets dropped
