We are running VSM 7.0.1. Recently, when replacing defective cameras in the system with 6000 series cameras, it seems to take several hours to overnight to be able to actually SEE the new camera on the network. What can be done to make the camera available to the network immediately?? Prior to install, the cameras are usually configured with ip, name and maybe time.
I also cannot log directly in to the camera itself. It's as if the camera isn't on the network at all.
It seems like this is a recent development. What could have changed??
I haven't the slightest. So you are staging the camera with some of the configuration before bringing it online in VSM? How are you adding it to VSM? Via the 'Replace Camera' functionality? What is the status of the VSOM 'Job' that gets kicked off to perform this? Does it finish in a timely fashion, or does it "take several hours to overnight'?
Bulletproof Solutions Inc.
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 220.127.116.11Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 18.104.22.168R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...