11-27-2009 12:21 PM - edited 03-09-2019 10:44 PM
Hi can anyone help me. I have a Cisco 1841 which has the follwowing
Readonly ROMMON initialized
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
As a consequence I cannot send a break sequence, I've also tried removing the compact flash card and the router simply loops stating,
Readonly ROMMON initialized
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
flash: CompactFlash not present.
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
c1841 platform with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
I've tried everything I can think of. There are several jumpers on the motherboard, x3 on the edge next to the fan power connector, Debug, Baud and WD, there is also a block of 5 in the centre of the board.
Is there any jumper configuration which will enable password recovery or is this router now a doorstop?