So - I've used many Cisco RV042/082 and have just purchased a couple previously used RV016 units.
The first think I do is hold down the "reset" switch until the units reset to factory and then proceed programming them - EXCEPT this last unit doesn't seem to be resetting the administrative password.
The unit has reset so that it is 192.168.1.1 and is handing out IP assignments via DHCP in that range.
When I point my browser (IE9) to the web page http://192.168.1.1 I am prompted to log on. I enter 'admin' for user name and attempt to enter the same for the password. The browser returns me to the logon prompt and after a few apparently failed attempts it displays a 401 error Unauthorized page.
In desperation I have tried:
admin / admin
/ admin
admin / password
/ password
admin / rv016
and simply admin with a blank password.
Isn't the admin password supposed to reset with everything else?
If not - how can I - if it is, then what would be preventing the admin password from resetting - is there an internal jumper or something I could try? I don't care about preserving any setting obviously I just want access to the admin interface.
Thanks to any and all with suggestions.
