Hey folks,
I have an RV320 router and fiber (CinBellTel Fioptics) to the house for near 1Gbps speeds, and am having issues getting the speed through my RV320. I know the router should do it (based on the SmallNetBuilder website testing), and I've disabled basically everything, but it seems to max out at 3-400 Mbps, tested with my SSD equipped MacBook Air with a 1Gpbs interface, but when I connect that same laptop directly to the fiber optic gateway I get +740Mpbs.
- I'm running firmware v1.2.1.14 (2015-08-13, 14:21:24)
- I only have the 1 WAN interface (WAN1)
- Inbound load balance is disabled
- Dual Wan is in Smart Link
- I've set the WAN1 Bandwidth to "1000000" for up and down (although for some reason I don't see the rate control options table in this article)
- LLDP disabled
- Bonjour disabled
- LAN1 set to high priority (all others set to Normal), all set to Auto/Gigabit
- LAN1 shows "LAN1 10Base-T/100Base-TX/1000Base-T Up Enabled High 1000Mbps Full Enabled"
- All firewall options disabled, no cookie blocking configured
- No VPN configured
Thoughts on what to try next?
Brett
