Hi,
I am trying to upgrade and configure my Nexus9000 C93108TC-EX. However the device boots directly into some kind of sub IOS and shoots straight into a "(none)# prompt. I tried to break out of it using several different methods found on the Internet, as well as attempting to boot from an IOS from my USB flash drive. I also tried a procedure I found that encompassed the below commands to no avail.
(none)# dir bootflash (none)# setup-bootvars.sh <aci_image.bin>
My question, therefore, is what do I need to do to get this thing to regular configuration mode so I can upgrade the IOS and configure it for production?
