03-09-2018 12:28 PM - edited 03-01-2019 05:28 AM
Pretty new to ACI, although I've been reading up quite a lot on the concepts. I just got the controller and switches, but I'm having difficulty with basic l2 connectivity between hosts. I've got a domain, VLAN, AEP, EPG set up, and have assigned that EPG to ports. However, the devices cannot ping each other (they're both in the same EPG).
I looked under the switch interfaces and saw that they're out-of-service. I cannot for the life of me figure out a. what this means, b. where to go in order to find out what it means.
Any advice?
eth 1/1-2 are the interfaces I'm talking about. They're on both switches.
Port Name Status Vlan Duplex Speed Type
----------------------------------------------------------------------------------------------
mgmt0 -- connected routed full 1G --
Eth1/1 -- out-of-ser trunk full 10G 10Gbase-SR
Eth1/2 -- out-of-ser trunk full 10G 10Gbase-SR
Eth1/3 -- notconnect trunk full inherit 10Gbase-SR
Eth1/4 -- notconnect trunk full inherit 10Gbase-SR