Hi!
I'm testing provisioning with C1111-8PLTEEA device and I found a strange behavior:
After config were deployed APIC-EM is reloading router.
Here is output from router console:
Mar 6 08:21:38.346 CET: %XML-SRVC: urn:cisco:pnp:config-upgrade XML Service(212) OK. PID=679
Mar 6 08:22:02.314 CET: %XML-UPDOWN: XEP_pnp-zero-touch_ XML Security(101) UNLOCKED. PID=679
Mar 6 08:22:11.166 CET: %XML-SRVC: urn:cisco:pnp:config-upgrade XML Service(212) OK. PID=679
***
*** --- SHUTDOWN NOW ---
***
Mar 6 08:22:16.211 CET: %SYS-5-RELOAD: Reload requested by controller. Reload Reason: Config upgrade.
In APIC-EM history info I see event "Running configuration upgrade to isr1100-test.txt was performed successfully"
Why I think that it is strange behavior, because I haven't seen this before with other devices: ISR4321, C1117-4PM and with some switches.
For example for C1117-4PM I see only two messages in APIC-EM :
Save startup Configuration was performed successfully
Device was successfully deployed!!
And router is not reloaded.
Uploaded config almost the same.
Does anybody knows why APIC-EM is reloading router ?
P.S After C1111-8PLTEEA is going up again from reload it is shutting down all interfaces except WAN. It just ignore "no shutdown" command in provisioned config.
