10-17-2019 08:50 AM
Hello,
AWS Site-to-Site VPNs typically provide two separate IPSec tunnels for redundancy (see diagram https://docs.aws.amazon.com/vpn/latest/s2svpn/VPNTunnels.html). Typically, an office router will be configured to connect to _both_ of these tunnels to prevent downtime in the event that 1 tunnel drops.
I was wondering if anyone had successfully configured an RV340 to use this dual-tunnel configuration with an AWS Site-to-Site VPN? I have tried:
* Configuring 2 Site-to-Site VPNs on the RV340, with the same Local/Remote Group that select traffic from the office router -> AWS VPC. When both VPNs are activated, traffic stops flowing.
* Configured 2 Site-to-Site VPNs using the "Inside IP Addresses" from AWS as the Local/Remote Group (169.254.x.x), and adding a Static Route to direct traffic at the tunnel. Traffic does not seem to be routed properly.
Does anyone have notes on how they have successfully configured an AWS Site-to-Site VPN using both tunnels with an RV340?
Thank you!