Hey guys,
I'm trying to set up failover for the RV345 router, so that when WAN1 goes down, everything switches to WAN2 (our second MSP). When I physically disconnect WAN1, it doesn't failover to WAN2.
In the Status and Statistics > System Summary page, it shows that the Multi-WAN status for WAN2 is offline even though I can ping the IP of WAN2. Can this have any effect on why it's not failing over? I've tried releasing and renewing the IP as well, but to no avail. WAN1 and WAN2 are set to precedence 1 and 2, respectively. I've attached a few screenshots of my configuration, and i'm currently on firmware version 1.0.03.16.
Any help would be appreciated, thanks!
