I did a config backup.
I downloaded 1.0.0.3.26 and did the update (without reset to factory checked).
When completed, the webgui login page was corrupt. It had spinning icon beside what should be the login button. see pic.
I tried old logins, but i dont even think the login button is working on login page.
I hard reset the router back to factory defaults.
I can tell this happened as config on LAN1 port changed back to factory defaults (dhcp in 192.168.1.1/24 range was re-enabled).
But i still get corrupted webui on login page.
I can't login in with factory default cisco/cisco.
Is there something i can do with the consoles port? Or is this a brick?
