Hey all, I'm trying to provision a fabric device as a border node, and I get the following error:
Failed to add device SW400-1.adamlab.local to the Fabric Site/Zone since 'ip routing' is not configured on the device. Please configure ip routing on the device, resync and retry the operation.
I've checked on the CLI of the devices that are doing this (SW400 above isn't the only one), and ip routing is indeed enabled (in fact its successfully using OSPF to even get to DNAC. If I look at the configuration of the device within DNAC, even DNAC sees the "ip routing" command is present. I've resynced countless times. Any ideas?
