Cisco 900 Series Router GUI (C921-4P)

[AlexM445]

Hello all,

I have a new and unconfigured, Cisco 900 Series Router, C921-4P. This router will be working with a CBS350 network switch and two CBW240AC access points. To program this router, is it CLI only or does it have a GUI (Similar to what you would find on a Linksys or Netgear router) and what is the process to activate it + a port to connect? I understand there are some topics about this, however, none of the solutions have worked thus far due to Cisco Configuration Professional being discontinued.

Thank you very much,

AM

[marce1000 · Accepted solution]

 - FYI : https://www.cisco.com/c/en/us/td/docs/routers/access/900/software/configuration/guide/900SCG.html

 M.