config router to pan or nat

[kc0hwa]

This is for Class

This is for Cisco CCNA 2

When configing Router with 2 subnet's lans' and wan

using pat or nat

do you

config two port on the router for lan

address that are privent that are part of the subnet

and

config one port on the router for wan

inside ip that is privent that are part of the subnet

set the wan inside ip to go to the internet

outside ip that is from the ISP

set rip 2

0.0.0.0 0 .0.0.0.0 to the inside ip that is privent on the wan

or

config two port on the router for lan

address that are privent that are part of the subnet

set the interface to inside

set the ip on the lan that can go to through the wan

and

config one port on the router for wan

outside ip that is from the ISP

set rip 2

0.0.0.0 0 .0.0.0.0 (to the wan"expole s0/.0/0 or fa0/0")

thank for the help

[kc0hwa]

or can any one exsplane configing net or pat

[mpyhala]

Hi,

Thank you for posting. Please see the following link for a good explanation:

http://www.webopedia.com/DidYouKnow/Computer_Science/2006/NAT_and_PAT.asp

[kc0hwa]

ya I have that

How to get a cisco Router configer

or inside and outside

or ports ip inside outside

[mpyhala]

Our Small Business routers are configured using GUI. For assistance with Cisco router CLI commands, please post at the following link:

https://supportforums.cisco.com/community/netpro/network-infrastructure/routing