cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
0
Helpful
1
Replies

Configure Client to Gateway VPN Connections - RV016

Jossyjohn
Level 1
Level 1

Hi Team

I have a Cisco RV016 VPN Router installed in my office.

I have a question with regards to configuring "Client To Gateway" VPN Connections.

I have configured Client To Gateway tunnels in the router. After that, I have configured L2TP/IPSec type VPN connection from my Windows 8 Laptop to connect to the office. In this connection, I have updated the Pre-Shared Key that is generated while creating the Tunnel etc. However, When I click on the conenct button, it prompts for the User ID and Password.

For the user ID, I use the Tunnel name I created. However, during the creation of Tunnel, I did not get an option to create a password and so I don't know what password should I use here? I tried to use the same Pre-Shared Key as the password, however my connection is failing and I am lost on what is to be done to fix this issue.

I would greatly appreciate any expert advise here on this matter.

Regards

Jo

 

1 Reply 1

Wizard4777
Level 1
Level 1

use the username and password you created for the vpn client uservpnuser.JPG