Does the RV345 support a site-to-site VPN tunnel and allow split tunneling?

[jeremy000]

I am looking at getting two RV345 units to connect 2 offices over the Internet via a site-to-site VPN tunnel.  I would like to specify so that only the other site's subnet is routed through the tunnel, and any other (Internet) traffic goes out to the regular Internet connection and not through the tunnel. 

I've read the instructions for the RV345 to see how to setup the site-to-site VPN and do not see an option for split tunnel in that section of the manual, so see it in other portions such as client-to-site tunnel.  Does that mean that if I setup a site-to-site VPN tunnel that ALL traffic is routed across the tunnel, or is only routing the subnet I setup in the "Local group type" in the site setup?  

[Iliya Gatsev · Accepted solution]

Hi, 

My name is Iliya Gatsev from Cisco Technical Support Team.

Yes, only the subnet specified under "Local group type" goes over the VPN tunnel.

Please rate this post or marked as answered to help other Cisco customers.

Iliya Gatsev
Cisco STAC Network Engineer
Together we are the human network .:|:.:|:. CISCO

[jeremy000]

Thank you for confirming!