How do I set up a 6to4 tunnel on RVS4000

[orvin_lau]

I have a Cisco RVS4000 with firmware version 2.0.0.3 which is configured in Dual-Stack Mode.  The Admin Guide for the RVS4000 say that "IPv6 hosts in the LAN are connected to remote IPv6 islands over 6to4 tunnels (per RFC3056)."  How do I set up the 6to4 tunnel between my RVS4000 and a tunnel provider?  There does not appear to be a screen to enter the address of the remote end of the 6to4 tunnel like 192.88.99.1.

[pvdzijden]

I second Orvin's request, I am also trying to get the RVS4000 to set up a tunnel to an ipv6 tunnelbroker and lack the proper options in the administration interface.

With the upcomming IPv6 day I'd like to have it sorted before hand, it's bad enough my ISP doesn't provide native IPv6 connectivity