How to configue Email, web, DNS and use NAT

[mrbbin9893788]

I can't configure to email and web. Can you help me, please ?

[luis_cordova · Accepted solution]

Hi @mrbbin9893788 

Compress your exercise (winzip) and attach it to check.

Regards

[mrbbin9893788]

My version is Cisco Packet Tracer 6.2, thank you very much.

[luis_cordova · Accepted solution]

Hi @mrbbin9893788 

I will try to tell you how to configure the requested services.
1-The servers must have a static IP that corresponds to the network that the server belongs to:

2-For the web service not much should be done, just verify that the HTTP and HTTPS services are turned on:

3-For the Mail service you must verify that it is turned on.
You must indicate the email domain and activate it with the "Set" button.
Then you must add the users that belong to this email domain:

Regards

[luis_cordova · Accepted solution]

Hi @mrbbin9893788 

For the DNS service you must verify that it is turned on.
You must indicate the name of the web page and the IP of the server where that service is hosted.
It is important that the PCs have the DNS server IP indicated:

Regards

I tell you that you can visit the Cisco Learning Network portal too.
Remember to mark the correct answers as solved, because that helps other users with similar doubts.

[mrbbin9893788]

Thank you very much, I did it